What is "Pathing Type" and Height Modifier in GB2 settings

[Cukie]

Just as the title says, what exactly does changing the Pathing Type option under the Paths section of GB2 settings do? One is Circle, the other is Bounce. And if I want my bot to fly a little lower than it is already set to do, I assume that i have to go into negatives to get it to fly a little lower? So if I set it to -3 for example, it will fly slightly lower than the original path?

 

[yt0k]

Circle follows the Gatherbuddy profile as it was recorded. Bounce well, bounces between the hotspots in the profile so you arent seen flying the exact same path.

 

[MadDog]

Height modifier, well, modifies the height of the hotspots. Eg. Hotspot x1526 y 2678 z 1362

After height modifier +10

X1526 y3678 z 1372

Hope i helped

 

[Cukie]

Height modifier, well, modifies the height of the hotspots. Eg. Hotspot x1526 y 2678 z 1362

After height modifier +10

X1526 y3678 z 1372

Hope i helped

So going into negative numbers on the modifier does lower the waypoints? I am looking to get more nodes per hour, so if I am looking to lower the flying path, so the bot doesn't have as far to fly up and down in between nodes/waypoints.

 

[MadDog]

So going into negative numbers on the modifier does lower the waypoints? I am looking to get more nodes per hour, so if I am looking to lower the flying path, so the bot doesn't have as far to fly up and down in between nodes/waypoints.

yes that would work