Some serious pathing/pulling issues ::PRIEST::

[Znyx]

Hey guys. I am just wondering a bit here. I recently updated to the new HB2, but im seriously disappointed. Atleast if this is due to the bot. I am using Bliiks profile 1-60 horde on a level 16 priest.

Its running near rachet around the road, it runs very specific to each hotspot lile HB1 does. However, it rarely pulls anything. It has to be within 30 yards, if not, it just ignores it.

Its taken it 4 hours to get 60% of level 16 lol. Is there a way for me to set it so it will walk towards mobs thats, lets say 70 yards away?

Here is a livestream so you can see what im talking about

Hm nvm. I just changed to a different profile with mobs closer.

 

[facemelter]

Hey Zynx, I struggled with the same issues. I felt as though my priest, which is now up to lvl 50, seemed to take a long time with that profile. In the Barrens I felt he ran around too much, and then when he advanced to Ashenvale he was constantly pulling multiple mobs. Which CC are you using? I found that using Kryses 1.16 updated by Raphus helped a bit in Ashenvale so not sure if that would help sooner since that is when I switched CCs. From reading these profiles, it seems that unfortunately priests are very slow to level this way. I think the profile is an excellent profile, just priests at low levels have a hard time dealing multiple mobs in some cases.

 

[Znyx]

Nvm got it. Thanks Facemelter, im trying the other CC. It looks dead similar to the beta one in the forum though.

Cheers

 

[raphus]

That's how HB works. There is an option in HB for pull distance. Set it to 40-45 yards and use Khyrptor. The CC will approach targets that are out of range.

There is currently a bug in HB for high pull distance values. HB will reselect a target after a given amount of time passes after pull triggered. So if it takes to much to approach a target, you may run an infinite loop between 2 targets apart.

 

[Znyx]

That's how HB works. There is an option in HB for pull distance. Set it to 40-45 yards and use Khyrptor. The CC will approach targets that are out of range.

There is currently a bug in HB for high pull distance values. HB will reselect a target after a given amount of time passes after pull triggered. So if it takes to much to approach a target, you may run an infinite loop between 2 targets apart.

Thing is, if i put it higher then 30, which is the longest range on my spells. It dont walk towards it, it targets it and tries to cast. So it keeps saying 'out of range'.

Actually with that CC it does move towards the target, but in steps of like 2 yards, thne stops then moves again. Looks very bottish.

EDIT 2. Sometimes it dont move towards it at all, i suppose i just gotta keep it to 30.