Properly setting up Que priority?

[xonoma]

I try to open it and edit and when I type my tanks in exactly as they are spelled out proper caps and spaces.. TL shows the que priority but does not follow the que priority at all. Can someone copy and paste the correct way to type a que priority for me? Id appreciate it I have to be doing something wrong.

 

[testerplutod]

Just paste this into your Tankleadersettings.xml and replace TANK1 ect. with your tanks's name.

<QueuePriority>
<Entry>TANK1</Entry>
<Entry>TANK2</Entry>
<Entry>TANK3</Entry>
<Entry>TANK4</Entry>
</QueuePriority>

 

[curep4]

This doesnt always work.. for example if you have a tank with similar name

KV and the KV-3 it will run both even though you just put KV in the tankleadersettings...

 

[Tony]

"Queue Priority
We generally recommend you use the settings interface over modifying the configuration file by hand.

There's one really important thing you should know about this setting: it uses the first vehicle it can find a match with the specified text with. This sounds more complex than it really is: if you have a "PzKpfw VI Tiger" and a "PzKpfw IV" in your garage, and you enter "PzKpfw" as your first priority, you can't tell which one it'll queue with - because both the Tiger and the IV contain the text "PzKpfw". Be as specific as you can be on this, generally typing the full name of the tank as shown in the garage is a good idea."

 

[Aevitas]

It does work for me currently, but after having taken a look at it again, it could use some improvement. In the upcoming update, full matches will take priority over partial matches. This basically means that if you have a KV, and you enter "KV" in the queue priority, that will be a direct match, and it will stop looking for something else. That should work a bit better!

Edit: I've been reworking the settings interface to make it much easier to set up your priority queue. It will be in the next release.