Hello everyone ! I'm new to the forum, been using HB lifetime for a week now. Everything is set up and working pretty well, but I got some minor issues. I would like to know if I did something wrong in the config.
I'm using GB2 and a pretty good profile in twilight highlands. But, when It dies, it's not using the spirit healer. It tries to go back to its corpse, using the ''spirit gryphon'', but as a ground mount. I checked Res spirit healer, and unchecked wait for res sickness, in the config. That resulted in my druid being stuck in a wall, dead, for all night.
Second minor issue, after mining a node, it sometimes go to travel form, or cat form, before using swift flight form and continue patrolling. In the config I wrote Swift flight form at both places asking for mount name, unchecked use random mount, and auto detect mount. And checked Use mount, next to the mount name.
Third, I put in the mailbox and vendor in my profile. But when it's time to repair or mail, it goes to travel form and runs to the vendor. Dying to mobs on the way.
And last, a small question, my druid stops a sec after each hotspot. As I read it's probably (correct me if I'm wrong) because the profile was made in 280% flying mount, is it possible to change so it uses 310% mount ?
Besides that everything is doing great. Thank you in advance for any advice !
I'm using GB2 and a pretty good profile in twilight highlands. But, when It dies, it's not using the spirit healer. It tries to go back to its corpse, using the ''spirit gryphon'', but as a ground mount. I checked Res spirit healer, and unchecked wait for res sickness, in the config. That resulted in my druid being stuck in a wall, dead, for all night.
Second minor issue, after mining a node, it sometimes go to travel form, or cat form, before using swift flight form and continue patrolling. In the config I wrote Swift flight form at both places asking for mount name, unchecked use random mount, and auto detect mount. And checked Use mount, next to the mount name.
Third, I put in the mailbox and vendor in my profile. But when it's time to repair or mail, it goes to travel form and runs to the vendor. Dying to mobs on the way.
And last, a small question, my druid stops a sec after each hotspot. As I read it's probably (correct me if I'm wrong) because the profile was made in 280% flying mount, is it possible to change so it uses 310% mount ?
Besides that everything is doing great. Thank you in advance for any advice !
