What's new
By:
  • Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • Visit Resources
  • Visit Downloads
  • Visit Portal

[HELP] Mesh / Revive Issue | profile added

  • Thread starter Thread starter chris_g
  • Start date Start date
C

chris_g

Guest
The bot is not using the given mesh after he died. He tries to run up a mountain which is pretty dumb. The revive path is connected to the main route! I attached the profile... plz tell me why he is not using the mesh properly, instead he tries to go through his own path (which is not working).
 
I always use "render" ... but when is a mesh not correct? Mesh-Points (blue dots on the ground) and the green lines are connected on the revive path... afterwards I use mass-meshing to cover a greater surface in order to be sure to not stuck somehow... I could add a "move to" so that you could test the profile as well.... or just move to sunblind ascent by yourself.
 
Make sure the blue dots have green lines between them. If the green lines go somewhere weird, which DOES happen, delete the mesh point and remake it.

If that's not your problem, I'll have a look at it later. Can you post a map screen shot of where the death walk spawn point is you're having problems with? It'll save me a lot of time tracking it down myself.
 
What is meant by somewhere? In respect to any line in the WHOLE mesh file? If that is meant, I wish to have another pathing system... I thought that is the thing which make meshing systems great.. they get the terrain in order to move right.... Please, I try to understand this thing as good as I can..
 
papatoast said:
Make sure the blue dots have green lines between them. If the green lines go somewhere weird, which DOES happen, delete the mesh point and remake it.

If that's not your problem, I'll have a look at it later. Can you post a map screen shot of where the death walk spawn point is you're having problems with? It'll save me a lot of time tracking it down myself.
Click to expand...

this and also make sure that you dont press jump while you recording a mesh
 
Ok well, the answers were not that helpful... because you somehow answered my points but not all were covered explicitly. so I just skipped this area and created a new one... I missed up to provide a screenshot for a starting point... I will do this later... because the profile itself is not the worst one... but somehow crazy because of the revive path :(

Update later on.
 
You must log in or register to reply here.
Back
Top