What's new
By:
  • Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • Visit Resources
  • Visit Downloads
  • Visit Portal

Fpsware Warlock: Shadow Walker

Status
Not open for further replies.
Works great on my toon (level 53, destro)

Only thing i would ask for is a level check for destro locks when the should cast Rain of Fire. Without Aftermath (level 54) Rain of Fire isn't worth casting, due to the fact you must channel it.
 
Drizzt1990 said:
Works great on my toon (level 53, destro)

Only thing i would ask for is a level check for destro locks when the should cast Rain of Fire. Without Aftermath (level 54) Rain of Fire isn't worth casting, due to the fact you must channel it.
Click to expand...

Simple enough, disable it in the UI until you're 54.
 
This CC is boss, been running it the past 2 days solid. Absolutely shredding through mobs, and watching my experience bar fly.
 
SVN has been updated.

Lots of little changes and tweaks.
Glyphs are now being detected properly, oops, my bad. This will have a huge effect on some classes.
 
Great work Fpsware, my lock hasnt died once unless a freak-incident like it would bodypull 7 mobs at once but that rarely happens.
 
great work, used ur cc in cata, big fan of ur work, i am running into a problem the cc seems not starting i was trying it on dummy but it seems it aint working as my toon standing still and not attacking. i have attached a log file
do mind looking into it and give me a solution ?

thanks in advance
 

Attachments

i just switched my spec to aff and the cc is working !!! destro seems not working
 
I'm seemingly having an issue that a few were a couple pages back where on say 3 - 4 mobs it'll stop casting on anything. Even manually targeting and casting something myself it doesn't seem to want to start. Here's a log of the little bit I did to see what was going on. Needless to say I can't make heads or tails of it lol.

Was in that starting section for horde in Pandaria, didn't do too much but stopped it after the casting stopped on the 3 - 4 mob pull. Thanks for any ideas/help :)
 

Attachments

q8devilish said:
great work, used ur cc in cata, big fan of ur work, i am running into a problem the cc seems not starting i was trying it on dummy but it seems it aint working as my toon standing still and not attacking. i have attached a log file
do mind looking into it and give me a solution ?

thanks in advance
Click to expand...

Good new is its not the CC.

Try a fresh install of HB or something like that.
 
Quadroon said:
I'm seemingly having an issue that a few were a couple pages back where on say 3 - 4 mobs it'll stop casting on anything. Even manually targeting and casting something myself it doesn't seem to want to start. Here's a log of the little bit I did to see what was going on. Needless to say I can't make heads or tails of it lol.

Was in that starting section for horde in Pandaria, didn't do too much but stopped it after the casting stopped on the 3 - 4 mob pull. Thanks for any ideas/help :)
Click to expand...

Use the latest SVN copy.
 
fpsware said:
Use the latest SVN copy.
Click to expand...

Log was after fully updated from SVN and starting it. I even tried to update again just in case *shrug* Mind you before the stopping of casting the thing is amazing so thats the only issue I noticed was the stopping if more than maybe 2 mobs.
 
Status
Not open for further replies.
Back
Top