Unable to save a new mesh.

[Gudentark]

Greetings.
I'm trying to create a new mesh file, so I load an empty .mesh file I created with notepad and an empty profile. I press clear mesh, and I then start mapping. When I'm done, I click the Save Mesh, and save it. However, when I go look at the Mesh file this time around, it was at the size of 0 byte.
I tried this several times, different areas, loading only a mesh, saving to the original mesh, saving to a new mesh etc.
Also, I've once before been able to create a succesful mesh.

I did search, and I found similar incidents, but whereas I believe I did those parts right.
But I really have no clue on this one - therefore help would be appreciated.

Thanks in advance.

 

[codex]

Are you sure you got English region settings?

 

[Gudentark]

I am not quite sure what you mean, I'm afraid of. Can you explain?

 

[_Hausi]

I think that HB uses the last used mesh. When you emptyed the mesh, you emptied the last used mesh, not your loaded. Maybe HB don?t load the empty file correct.
Look in your Navigate Log window.
There should be logged where HB saved your routes ^^

 

[Gudentark]

Thank you, I had to load the profile and mesh, then START HonorBuddy and then stop it again, for it to save it properly to the correct mesh. Else it did indeed save it to the last used mesh. Thank you.

 

[codex]

I am not quite sure what you mean, I'm afraid of. Can you explain?

Goto control panel and go to the "Region and Language". In there change the format too "English (United States).. This should do the trick...

 

[_Hausi]

Thank you, I had to load the profile and mesh, then START HonorBuddy and then stop it again, for it to save it properly to the correct mesh. Else it did indeed save it to the last used mesh. Thank you.

Cool np

Hawker, can you check it or should i post it in HB rls thread?

 

[Impurity]

I have this problem too, though these trouble shooting steps dont work.