[RePear] Repair Bot for Rebornbuddy Updated

[Warcren]

Hello everyone I modified some of the original code by kagamihiiragi17 and the edits done by metrosound, plugin should be working again and it also works with ExFateBot.

All credit goes to kagamihiiragi17 for the original development of this plugin and metrosound for adding all the Hevensward zones and Vendors.

v3.0.5
**Backup everything, always....**

- Changed the build version to differentiate with the previous version.
- Tweaked the movement logic.
- Tweaked the way it determines which mender is closest.
- Dismount before targeting Npc.
- Added a check to see if you're dead before trying to repair.
- Cleaned up the code a bit.

NOTE:
RePair does not work properly with Ultima Combat Routine. If you plan on using just one class during your whole session it might work but if you change to a different class while using Ultima it will lock the plugin to the previous class. Works with FFXIV All in One, YourRaidingBuddy and Kupo. For best results use Kupo.

SVN Link

Original RePear thread here.
Edits by metrosound here.

 

[BruddahWan]

Well done! It seems to work well so far and thanks for mentioning that issue with Ultima, would have gone mad trying to figure it out.

 

[ffvicio]

So, i tried to use with when using Orderbot on gathering ( botany ), it went to npc , but keep trying to get back to gathering and no repair.

Going to try get a clear log later.

 

[BruddahWan]

It looks like it gets stuck in Western Highlands.
It says it's going to be repair, but ends up flying up and stopping there with the log just showing that repair conditions have been met.
I didn't test it fully, but it seemed like other maps were ok.

Any ideas?

 

[BruddahWan]

Just wanted to add that very often, it spazzes out near a repair NPC, just jitters around non-stop, never actually speaking with the NPC to repair and gets stuck in that loop of "repair conditions have been met".

 

[Reaux]

It does not repair items when in Coerthas-Camp Dragonhead map. It just runs in circles beside the mender. I use Kupo CR with this. How can i fix this?