HB5326D21
New Member
- Joined
- May 9, 2011
- Messages
- 83
Is something going on with HB? Seems as time goes on, it's messing up more and more. For instance... I'm running GB2 mining profiles such as
(A)Znuff's Twilight Highlands Ore Run v1
GB2_Twilight Highlands v3.5Alliance
w00tsTwilightHighlandsMiningAlliance091811
Znuff-TwilightHighlands-Ore-RoutesBuddy
I set them to only mine in the bot configuration, and the settings
I have tried setting GB2 to both ninja nodes and not ninja nodes. I've set it to Ignore nodes with elites around it and vice versa. I've played with the height adjustment on all profiles too just in case it might be the profiles might be too high.
I sit and watch it as I use the various different profiles and HB misses almost as many nodes as it picks up. I'm not talking about missing one or two here and there, but in an hour's time, no matter which profile I'm using, it's avoiding nodes that is should never avoid. Then of course there is the irritating issue that it detects a node, goes to it and maybe slides off the side down a hill or just falls and instead of trying to find a path back to it and mine it, it just mounts and flies off! I can stop HB, go to the node and mine it and then restart it and wait for it to miss another, then I rinse and repeat the start stop again. In an hour's time I can miss as much as 100 ore depending on how many are norm nodes and Rich nodes that it's missing. It used to never be this bad. Did pathing get mucked up or something?
(A)Znuff's Twilight Highlands Ore Run v1
GB2_Twilight Highlands v3.5Alliance
w00tsTwilightHighlandsMiningAlliance091811
Znuff-TwilightHighlands-Ore-RoutesBuddy
I set them to only mine in the bot configuration, and the settings
I have tried setting GB2 to both ninja nodes and not ninja nodes. I've set it to Ignore nodes with elites around it and vice versa. I've played with the height adjustment on all profiles too just in case it might be the profiles might be too high.
I sit and watch it as I use the various different profiles and HB misses almost as many nodes as it picks up. I'm not talking about missing one or two here and there, but in an hour's time, no matter which profile I'm using, it's avoiding nodes that is should never avoid. Then of course there is the irritating issue that it detects a node, goes to it and maybe slides off the side down a hill or just falls and instead of trying to find a path back to it and mine it, it just mounts and flies off! I can stop HB, go to the node and mine it and then restart it and wait for it to miss another, then I rinse and repeat the start stop again. In an hour's time I can miss as much as 100 ore depending on how many are norm nodes and Rich nodes that it's missing. It used to never be this bad. Did pathing get mucked up or something?
