mrgalabama
New Member
- Joined
- Jan 15, 2010
- Messages
- 63
- Reaction score
- 0
i been making herbing profiles. all of them are very big and cover 95% of the herbs on the map. as i make profiles and watch them run i notice that gb ignores my range "harvest range for ground mount" setting. it is set to 5. the reason why is that my path and angles i run i try hard not to cross over certain terrain or i might need to go up a mountain at a certain angle to be able to run up it. but i notice GB with go after nodes that are over 30-40 yds away when its set to 5. is there a way to make gb not go after nodes that are over 5-10 yds away?? this makes the profile get stuck a lot when its around mountains. cause it will go after a node and get stuck in the ridges of the mountain because of the node is over 30yds away. if this wasnt happening it wouldnt get stuck.
am going to attach the profile i been working on for over a week and cant get gb to run it right for the settings. also i will post a map so you can see the path. i dont wont gb going more than 5-10 because the path is close it runs will cause it to get stuck in places where herb are abundant. i made the path to run over must of the herbs so it doesnt have to leave the path to chase down a herb.
i hope i post everything that is needed to help me with this issue. i been trying to make profiles that cover the entire map.
am going to attach the profile i been working on for over a week and cant get gb to run it right for the settings. also i will post a map so you can see the path. i dont wont gb going more than 5-10 because the path is close it runs will cause it to get stuck in places where herb are abundant. i made the path to run over must of the herbs so it doesnt have to leave the path to chase down a herb.
i hope i post everything that is needed to help me with this issue. i been trying to make profiles that cover the entire map.
Attachments
Last edited:
