What's new
By:
  • Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • Visit Resources
  • Visit Downloads
  • Visit Portal

GB2 under HB fails to target mobs, spirit healer, repair npc, and more

BlackPrapor

BlackPrapor

New Member
Joined
May 7, 2010
Messages
285
Reaction score
1
I've got an issue with targeting mobs. Bot doesn't target them sometimes and just stand there and die. I've got mailbox and repair npc in my profile. It fails to use spirit healer, but I click it manually anyway, then runs for the cave to repair. When in the cave, it automatically dismounts from seahorse and tries to mount it again, receiving an error "you can mount it only in the water"(eternal loop). Settings ground mount, flying mount, auto select mount, random mount, into both general and gatherer settings haven't changed a thing - it keeps jumping. Then I switch off HB, and move to the repair npc, then switch on HB again - it opens npc dialog window then nothing happens. Also, when swam out of the cave to try it again, it went to the following spot:
<Hotspot X="-6012.551" Y="4273.915" Z="-368.3053" />
which is in the water, but apparently considered to be the ground and gets dismounted and same jump loop starts over again. I've tried to submit this via bug reporter, but it's bugged, not sending anything.
 

Attachments

I can't look at your log ATM, but disable all addons, reset all keybindings and try again. The jumping happened to me for a while and resetting the bindings fixed it. The targeting and such is most likely your cc failing.
 
Hope it helps, if not you'll have to wait or someone else, or for me to get home and look at your log. Going to be several hours.
 
nope, it doesn't help. He stands with his back to the mob, if I try to face the mob, he makes a few strikes, then turns around with his back to the mob again and keeps standing. Also tried to switch off all plug-ins in HB, didn't help.
 

Attachments

Last edited:
It's a warrior, there is only one CC available. I've tried to run without CC, failed as well.
 
You need to look on the forums for a new warrior CC, download it, put it in the Custom Classes folder where you installed Honorbuddy. Restart honorbuddy and click configure CC.
 
Lionheart: "no movement, no targeting, no pulling logic". Ensemble got same issues, as people report (I also tried this CC with my shadow priest, it didn't work at all), so there is only one CC which at least partially works. It seems that I have to write CC myself to get anything working, but I'm not so good with VS or C++. I'd say the default class should do all the job, since it's not possible for the bot to perform any job (grinding, farming, questing) without successfully killing mobs it encounters, but it's all we have atm.
 
Last edited:
Lionheart CC ignores all mobs, Ensemble CC uses auto attack only - works on single mob, if more the toon dies.
 
I got the same error in the log as BlackPrapor. Also, I have a warrior with that CC, so it pretty much is the fault of the CC for sure.
 
When I use Ensemble, it targets as it should. The only problem then is that my warrior merely auto attacks with that CC; which still is better than sometimes just not doing anything.
 
Last edited:
Matador said:
When I use Ensemble, it targets as it should. The only problem then is that my warrior merely auto attacks with that CC; which still is better than sometimes just not doing anything.
Click to expand...
I specced my warrior to prot, and left it overnight using Ensemble bot - 0 deaths, loads of grass in my mail =)
 
You must log in or register to reply here.
Back
Top